A NiCrAlY coating has been prepared by electrospark deposition (ESD) technology on gun steel and its isothermal oxidation behavior at 950°C investigated. The results indicated that the NiCrAlY coating consists only of a homogeneous single -NiAl phase; NiCrAlY coatings substantially increase the high-temperature...

The pure silica hydrosol and phosphorus-doped silica hydrosol was prepared using sol-gel method with methyltrimethoxylsilane(MTMOS) and tetraethoxysilane(TEOS) as precursors and ammonium biphosphate as a flame retardant(FR) in the presence of hydrochloric acid and cationic /nonionic surfactants in aqueous...

Composite (CrAl)N and (CrAlSiY)N hard coatings were deposited on 1Cr11Ni2W2MoV steel substrates by arc ion plating system under negative bias of 0 V, 100 V and 200V respectively. Pulsed bias gave rise to the deviation of elements, the decreased deposition rate, and the change of the preferred orientation,...

The heater structure plays an important role in the chip-scale atomic clock (CSAC) to achieve the performance of low power consumption, and it is the most effective way to make the structure by depositing the indium tin oxide (ITO) for its heating performance and transparent property. The influence of...

Positively charged cellulose derivative quaternized cellulose (QC), was layer-by-layer (LbL) assembled with negatively charged cellulose derivative carboxymethyl cellulose (CMC) to produce the thin film. The factors of dipping and rinsing time on the thin film growth were investigated. FT-IR confirmed...

Aiming at the machining difficulty of a large thin sheet part, high speed milling and a vacuum fixture are used to reduce its machining deformation and errors. The vacuum fixture suitable for the machining of the large thin sheet part is designed and fabricated. It is able to clamp the large thin sheet...

Microcellular foam injection molding process is a new technique and widely used in different industries nowadays. However, most products have surface defects that limit this process usage. This paper introduces different methods used on improving microcellular foam injection molding parts surface quality....