A first-principle study on the conductive path formation induced by the aggregated O ions in the defected titanium dioxide (Ti12O29) is reported. The result illustrates that the O interstitials induce the aggregation of the O-ions. Thus, the formation of the conductive path is attributed to the continuous...

With the development of the Internet, a variety of attack behaviors are emerging, which seriously threaten the security of cyberspace. In order to effectively defend these attacks, the researchers put forward a variety of research methods. During these methods, using simulation software to model the...

In this paper, first, a new predictor-corrector method( called the modified predictor-corrector method ) for the fractional differential equations is developed. And the new method can be formally viewed as a modification as the classical predictor-corrector method. Second, it is proved that the numerical...

Made the modal analysis of BTA drill pipe by ANSYS software,analysis the modal of the BTA drill pipe when encountered the excitation frequency in the actual processing.Determine the appropriate drill pipe vibrations at different excitation force, to further optimize the design of the drill, provide the...

This paper describes a testing system of thermal transfer label printer based on virtual instrument technology. The hardware of this system uses data acquisition card, signal condition board, while its software is developed on LabVIEW. This system can realize the automated testing for various features...

Aiming at classical DV-Hop localization algorithm has a big positioning error in the situation that network nodes distribute unevenly, an improved DV-Hop algorithm is put forward. The anchor node’s hop distance will be revised by hop counts in the parking lot of location model and hyperbolic positioning...

This paper designs a low-cost embedded GPS/INS integrated navigation module ,using STM32 as control processing unit and the micro inertial measurement unit (MPU6050) as the sensor and GPS receiver. The GPS receiver is easily to be derived of navigation function because of the lock-loss when vehicles...

The whole system is composed of STM32 embedded system module, gyroscope MPU 9150 module, DC Blower module,trestle module,power module, LED and LCD display module, key mode selection module,alarm module.Wind pendulum control system is based on STM32 embedded system, using STM32 as control system,using...

Infrared thermography has been a very important nondestructive evaluation (NDE) in the detection of concrete due to its non-contactness, rapidity, capability of imaging large area. More generally, there are some frames in the infrared image sequence. It costs more time to read the information behind...

Precast concrete shear walls are capable of providing preferable lateral strength and stiffness under earthquake loading and thus they are frequently employed in the moderate and high seismic risk regions. Guided by the building industrialization advocated by the government of China, domestic scientific...

In order to ensure the accuracy and precision about the trace of the autonomous vehicle for the sea floor prospecting, double- ring, series –connection closed-loop control mode is used in the paper. Fuzzy controller is used for controlling velocity in the inner-ring, and fuzzy neutral network controller...

For complex Ad Hoc network environment, based on Elman neural network prediction model, using particle swarm optimization algorithm to optimize the original Elman BP training can find the global optimization thresholds and weights of the neural network layers, and a modified Elman neural network model...

With the development of web 2.0 technology, all kinds of services based on web have appeared many new features. The invasion methods and attack technologies aimed at web service side are becoming more and more diverse, which threaten the security of network seriously. Therefore it is necessary to research...

Based on the first question of problem B in the National Undergraduate Mathematical Modeling Contest of the Higher Education Cup in 2015, this model would quantify some relevant indexes to analyze the degree of supply and demand for taxicab resources. In view of this question, this paper would estimate...

This model is based on the problem B in the Mathematical Modeling Contest of North China Electronic Power University in 2015. It works out solutions for non-overlapping box arrangement with load-bearing limits and without bearing limits, which can finally solve the practical loading problem of overlapping...

With the rapid development of social network, analysis for online users’ emotions and tendencies has gradually developed. Sentiment analysis and social relations analysis on social network has made significant progress. Based on data mining, this study summarized the existing work about users’ emotion...

In this paper, we focus on the need for temperature field analysis of gear transmission, as a important issue related to gear transmission’s reliability. Most of previous studies were based on traditional heat transfer theory, focusing on numerical analysis method, however oil cooling effect has not...

Reliability evaluation of the electric vehicle in the grid of random charging and discharging behavior is particularly important. To solve these problems, a mode is proposed in the time and space by their random behavior, probability density function based on the statistical analysis, and the bind distribution...

The drawing mold of Miniature Inner Grooved Copper Tubes (MIGCT) is made of WC-Co hard alloy, TiAlN coating is deposited on the substrate of WC-Co hard alloy. Inspections on binding force and hardness show that TiAlN coating is provided with fine surface finish and can meet the requirement of industrial...

In order to reveal the machining mechanism of the inter electrode gap during ultrasonic assisted electrical discharge machining, the relationship between the distribution of the flow field and bubble motion was studied. The three-dimensional model of deep hole machining was established firstly using...

Micro holes were formed on GH4169 super alloy using a millisecond pulse Nd:YAG laser with a average power of 65J and positive defocus of 3mm from the sample surface. The microstructure of the micro hole including morphology and elements composition were analyzed using Scanning Electron microscopy (SEM),...

The structural failure of storage tank under internal overpressure mainly have two forms: uplift deformation and corner weld avulsion. And tank bottom is a sensitive position. A practical case of tank bottom deformation was detected in 2014. Based on this practical engineering case, tank bottom structure...

The accuracy and reliability of the main components of travelling wave natural frequency is the key of travelling wave in the fault location method based on the natural frequency. To avoid the problem that traditional algorithms rely on a single primary natural frequency are not reliable, a new method...

Conflict operations seriously affect the performance of man-machine interaction in time-critical domains. Even conflict sometimes adversely impacts on safety operation. Based on collaboration task analysis, the hierarchy of comprehensive evaluation index system of conflict operations was established...

Scratched alkyd varnish coating (AVC) with isophorone diisocyanate (IPDI) microcapsules as functional additives display self-healing properties. Here, we investigated the mechanism of the self-healing process using a water trigger in seawater. FT-IR spectra of the self-healing products in the scratched...

The purpose of this paper is to examine whether low pressure cold spray can deposit high quality Al-PTFE Composites Coating or not. Different Polytetrafluoroethylene (PTFE) content Al-PTFE composite powders were used to deposit composites coating with low pressure cold spraying methods under the parameter...

In this paper, boron doped diamond (BDD) thin flms have been deposited on Ti-based substrates with or without a Ta intermediate layer by microwave plasma chemical vapour deposition (MWCVD). Raman spectroscopy and scanning electron microscopy (SEM) examinations demonstrate that the electrode has well-defined...

The RuO2- IrO2-SnO2/Ti anodes were prepared by the sol–gel procedure. SEM, EDX and XRD showed that the rutile structured RuO2–IrO2–SnO2 solid solution was formed after pyrolysis, the solid solution structure and active components were almost disappeared after the deactivation of the anodes. Electrochemical...

In this paper, a novel SIRS model of rumors on scale-free network with time delay is proposed. The basic reproductive number for the model is presented. We prove that the rumors will die out when the basic reproductive number is less than the unity. Whereas the permanence of the rumors is shown if the...

A novel ultra-wideband ( UWB) antenna is proposed in this paper ,which has a band-notched characteristic for the interference between the UWB applications and the IEEE802.11a wireless local area network (WLAN) and the WiMAX /C-band with combination of notched structures. The proposed antenna fed by coplanar...

When the information network of an enterprise grows to a certain size, higher requirements will be set to the security and the use of network resources maximum effectiveness. In the current internal network of an enterprise, various needs of IT applications of the enterprise can be met by commonly using...

Based on the virtual reality technology, we developed a training operation skill system for elevator by the modular design. It would be applied to assess workers for elevator. According to the country assessment outline, the system realized the functions of theory and operation skill training. In addition,...

Aiming at the problem of assistant teaching and training system for the elevator operator and maintenance operators, the present professional training patterns were analyzed. The virtual elevator system was applied to the elevator training areas, based on the ‘Examination requirements for Safety Administrator...

Positioning technology based on the sun's shadow is a method through the analysis of the sun's shadow change of object to determine the location of object. We can use our own shadow to positioning ourselves when there is no GPS. But how to estimate it? First of all, we need to use secondary polynomial...

This paper addresses a reliability optimization problem, where the motive is to select the best optimization method for complex nonlinear system. In order to avoid blind and repeated searching of chaos optimization in searching space of complex nonlinear system, an improving mutative scale chaos optimization...

The core problem of cloud computing is to deal with the dynamic scheduling problem of physical and virtual resource, which can be regarded as a new problem in cloud computing, in order to achieve energy saving and emission reduction with high performance and low investment as well as some other targets....

The high voltage source of electrocurtain requirements for high power factor, high efficiency, output DC high voltage of low ripple, fast fault response. In order to improve the parameters to design a high voltage source which based on three-phase buck type PWM AC chopper. It has advantages of simple...

Electrical module is the control unit of oil and gas processing, so it must have the ability to withstand the impact of the explosion. By transient dynamic module of ANSYS, dynamic response of electrical module under explosion load is analyzed. The results show that the maximum stress and displacement...

The output of photovoltaic array under non-uniform light is nonlinear with multi peaks. Since the traditional MPPT algorithm based on particle swarm optimization (PSO) is likely to fall into premature convergence and may work slower in the later iterations, the MPPT method based on improved PSO with...

This paper focuses on the mode-coupling characteristics of gyroscope, and tries to rebuild a more perfect system model of silicon micro-machined gyroscope. It analyses the factors causing the coupling motions between drive-mode and detect-mode of gyroscope system. The mathematical model is deducted out...

In WDM optical networks, the consistent variation of quality of service (QoS) demand has conducted the advent of sliding scheduled traffic, which does not have a rigid deadline and allows flexible sliding within a large time window. In this paper, the static sliding scheduled lightpath demand (SSLD)...

Cyclostationary statistical characteristic is the main theory of studying non-stationary periodic signal. Signal and noise are always assumed that obey Gaussian distribution model in traditional signal’s processing. As the environment of non-Gaussian pulse is increasing complex, degradation problems...

Emulsifier is the key equipment in the production of emulsion explosive. The condition of the emulsifier is very important to the production safety of the emulsion explosive. The paper focuses on emulsifier fault warning in the production of emulsion explosive. Now the emulsifier fault warning is based...

This paper is concerned with the existence of exact traveling wave solutions of nonlinear evolution equations by the tanh-function method.The validity and reliability of this method is demonstrated by applying it to the Fisher-KPP equations.

In April 2020, Atlantis Press was alerted to fake proceedings articles hosted on our platform. These articles, mostly in computer science and engineering, were generated by the SCIgen computer program and were all published between 2006-2018. Immediately after receiving the alert, Atlantis Press initiated...

Theoretical line loss calculation is the basis for line loss analysis, and reduce the time of calculating the theoretical line loss can improve the efficiency of the line loss analysis.This paper,aiming at the wasted issue in power transmission,presents a theoretical line loss calculation framework that...

In the twenty-first century, the life science has been studied from the genome research into the structure and function of the structure, which can further reveal the mystery of life. In this paper, it takes the relationship between protein structure and its function as the breakthrough point, with the...

Taking a certain type of photoelectric system of armored vehicle as an example, the influence of angular vibration on the optical system image quality is analyzed. Firstly, the paper introduces the characteristics of photovoltaic system and the basic theory of imaging; Then it uses the ZEMAX to build...

This paper analyzed the current situation of integration management for payment channels in Jibei Electric Power co., LTD of State Grid, and then proposed an effective solution of GIS-based payment channel integrated management platform. The design of the platform is based on the existed integrated payment...

With the help of statistical software Eview6.0, qualitative analysis is carried out of China's civil aviation passenger traffic since reform and opening up. It is found that China’s civil aviation passenger traffic development experienced three stages: slow development stage from 1978 to1990, relatively...

With the rapid development of Internet, the computer network is gradually becoming a country's economic development foundation and lifeblood of the world dependent on the network is also growing, network security issues attendant becomes increasingly prominent. Network security infrastructure Laboratory,...

With the development of network information technology and multimedia technology, require Web sites with convenient, fast and efficient features, interactive website built into the current research focus. The use of interactive, resource sharing, this paper describes the development of interactive multimedia...

Concepts, architecture, data analysis and processing methods and other technical requirements in the standard Internet of things systematically optimize and improve existing building energy consumption monitoring theory, network architecture and implementation of technology, the concept of building energy...

With the pace of modern life continues to accelerate, it will allocate more time to work, while ignoring the importance of physical exercise, which virtually led to a decline in physical fitness. The best way to solve this problem is to develop a set of easy-to-install, inexpensive sports teaching system,...

With the proposed concept of things, things technology in logistics and distribution will promote the further development of logistics and distribution. Based on the current status of domestic and international distribution logistics comparative study found insufficient logistics existing in our country...