Study on Lapping Position Control of Spiral Bevel Gear Based on NURBS Surface Fitting

DOI

10.2991/icadme-17.2017.19How to use a DOI?

Keywords

Spiral bevel gear; Lapping; NURBS surface; TCA; Position control

Abstract

The lapping quality and meshing performance of spiral bevel gear depend highly on the exact control over the lapping position on tooth surface. In this paper, the non-uniform rational B-spline (NURBS) surface is used to fit the real measured tooth surface. Based on the tooth contact analysis (TCA) for real measured tooth surface, the mathematic relationship between the adjusting parameters (V/H/J) of lapping movement and meshing position is established. The fixed point lapping and whole tooth surface lapping can be achieved through the lapping point control over position and movement direction.

Copyright

© 2017, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Jianjun Yang
AU  - Linnan Liu
PY  - 2017/07
DA  - 2017/07
TI  - Study on Lapping Position Control of Spiral Bevel Gear Based on NURBS Surface Fitting
BT  - Proceedings of the 2017 7th International Conference on Advanced Design and Manufacturing Engineering (ICADME 2017)
PB  - Atlantis Press
SP  - 103
EP  - 106
SN  - 2352-5401
UR  - https://doi.org/10.2991/icadme-17.2017.19
DO  - 10.2991/icadme-17.2017.19
ID  - Yang2017/07
ER  -