Proceedings of the 3rd International Conference on Material, Mechanical and Manufacturing Engineering

Analysis on the wrinkling in continuous roll forming of three-dimensional surface parts

Authors
Weixue Hu, Qingmin Chen, Xueping Yan
Corresponding Author
Weixue Hu
Available Online August 2015.
DOI
https://doi.org/10.2991/ic3me-15.2015.37How to use a DOI?
Keywords
Continuous forming; Rolling; Wrinkling; Numerical simulation; Three-dimensional surface
Abstract
Continuous roll forming is a new sheet metal forming process for three-dimensional surface parts. In the process, the sheet metal is thinned non-uniformly in transverse direction by controlling the distribution of the gap between the upper and lower forming rolls, the longitudinal elongation is different, which makes the sheet metal generate a doubly curved surface parts. When sheet metal forming, the complex stress state produced in the sheet. Since the size in thickness is much smaller than in the transverse and longitudinal directions, the energy required for the deformation of the thin plate is small, it is easy to produce wrinkling problems. In this paper, finite element analysis model is established, wrinkling in the spherical surface and saddle surface are simulation and the experimental results of the wrinkling in saddle surface is presented. The results demonstrate that unreasonable distribution of the roll gap is the main reason for the generation of wave-shaped wrinkling.
Open Access
This is an open access article distributed under the CC BY-NC license.

Download article (PDF)

Proceedings
3rd International Conference on Material, Mechanical and Manufacturing Engineering (IC3ME 2015)
Part of series
Advances in Engineering Research
Publication Date
August 2015
ISBN
978-94-6252-100-1
ISSN
2352-5401
DOI
https://doi.org/10.2991/ic3me-15.2015.37How to use a DOI?
Open Access
This is an open access article distributed under the CC BY-NC license.

Cite this article

TY  - CONF
AU  - Weixue Hu
AU  - Qingmin Chen
AU  - Xueping Yan
PY  - 2015/08
DA  - 2015/08
TI  - Analysis on the wrinkling in continuous roll forming of three-dimensional surface parts
BT  - 3rd International Conference on Material, Mechanical and Manufacturing Engineering (IC3ME 2015)
PB  - Atlantis Press
SN  - 2352-5401
UR  - https://doi.org/10.2991/ic3me-15.2015.37
DO  - https://doi.org/10.2991/ic3me-15.2015.37
ID  - Hu2015/08
ER  -