Experimental research on the continuous roll forming of three-dimensional surface parts

DOI

10.2991/asei-15.2015.43How to use a DOI?

Keywords

Continuous forming; Flexible roll; Rolling speed; Three-dimensional surface

Abstract

Continuous roll forming is a new sheet metal forming process for three-dimensional surface parts. In the process, the sheet metal is thinned non-uniformly in transverse direction by controlling the distribution of the gap between the upper and lower forming rolls, the longitudinal elongation is different, which makes the sheet metal generate a doubly curved surface parts. The rolling speed and the thickness of sheet metal etc. have great influence on the forming results. In this paper, a series of experiments of continuous roll forming have been carried out, the radii of curvature in the longitudinal and lateral directions were measured, and the effects of the rolling speed and the thickness of sheet metal are obtained.

Copyright

© 2015, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Qing-Min Chen
AU  - Wei-Xue Hu
AU  - Xue-Ping Yan
PY  - 2015/05
DA  - 2015/05
TI  - Experimental research on the continuous roll forming of three-dimensional surface parts
BT  - Proceedings of the 2015 International conference on Applied Science and Engineering Innovation
PB  - Atlantis Press
SP  - 206
EP  - 209
SN  - 2352-5401
UR  - https://doi.org/10.2991/asei-15.2015.43
DO  - 10.2991/asei-15.2015.43
ID  - Chen2015/05
ER  -