Proceedings of the 2015 International Conference on Structural, Mechanical and Material Engineering

Statistical modelling of the spring back behavior for bending of v-shaped parts from common sheet metal

Authors
Draghici Constantin
Corresponding Author
Draghici Constantin
Available Online November 2015.
DOI
10.2991/icsmme-15.2015.25How to use a DOI?
Keywords
Statistic Modeling, V – Banding, Spring Back Behavior, Smallest Squares Method
Abstract

This paper presents the experimental program and measured results, obtained model, statistic analysis and some graphics for springback angle of common sheet metal. There were considered three bending parameters: bending’s angle, sheet’s thickness and radius’ punch. The obtained model is interactive second order polynomial ones. There are also presented some observations and a few relevant conclusions regarding the obtained results.

Copyright
© 2015, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

Volume Title
Proceedings of the 2015 International Conference on Structural, Mechanical and Material Engineering
Series
Advances in Engineering Research
Publication Date
November 2015
ISBN
10.2991/icsmme-15.2015.25
ISSN
2352-5401
DOI
10.2991/icsmme-15.2015.25How to use a DOI?
Copyright
© 2015, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Cite this article

TY  - CONF
AU  - Draghici Constantin
PY  - 2015/11
DA  - 2015/11
TI  - Statistical modelling of the spring back behavior for bending of v-shaped parts from common sheet metal
BT  - Proceedings of the 2015 International Conference on Structural, Mechanical and Material Engineering
PB  - Atlantis Press
SP  - 107
EP  - 110
SN  - 2352-5401
UR  - https://doi.org/10.2991/icsmme-15.2015.25
DO  - 10.2991/icsmme-15.2015.25
ID  - Constantin2015/11
ER  -