Cutting Force Investigation when Heavy Milling Welded Aluminum-Thin- Walled Hollow Structure
- DOI
- 10.2991/icmsa-15.2015.182How to use a DOI?
- Keywords
- Aluminum, Thin-walled Hollow Structure, Heavy Milling, Cutting Forces.
- Abstract
Commercial cutting tools of sintered high speed steel and carbide were used to heavy milling 6N01-T5 aluminum thin-walled hollow W-shape structures under four kinds of cooling conditions. The results showed that the cutting forces increased dramatically when cutting the weld seam or the intersectant ribbed slab where the value of cutting forces were over ten times bigger than those of cutting the single ribbed slab. Among the four cutting parameters, radial depth of cut was the most significant influence factor and followed by feed rate and axial depth of cut. Spindle speed had a less influence. The optimum combination of cutting parameters for the cutting vibration experiments was 3000 rev/min for the spindle speed, 0.05 mm/tooth for the feed rate, 5 mm for the axial depth of cut and 5 mm for the radial depth of cut. The results also showed the order of the effectiveness of the cooling methods on reducing the cutting force was cryogenic pneumatic mist jet impinging (CPMJI), pneumatic mist jet impinging (PMJI), cryogenic wind and dry cutting.
- Copyright
- © 2015, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Ying-Fei Ge AU - Jun-Ming Hou AU - Chun-Guang Li AU - Wen-Liang Xiong PY - 2014/06 DA - 2014/06 TI - Cutting Force Investigation when Heavy Milling Welded Aluminum-Thin- Walled Hollow Structure BT - Proceedings of the 2015 International Conference on Material Science and Applications PB - Atlantis Press SP - 979 EP - 985 SN - 2352-541X UR - https://doi.org/10.2991/icmsa-15.2015.182 DO - 10.2991/icmsa-15.2015.182 ID - Ge2014/06 ER -